Tested and proven resiliency to 50kilorad of total ionizing dose and immune to single-event upsets
Andover, MA –– Vicor (VICR NASDAQ) today announced the launch of its first radiation-fault-tolerant DC-DC converter power modules, housed in the new Vicor plated SM-ChiP™ package.Capable of powering low-voltage ASICs of up to 300 watts from a 100V nominal power source, the ChiPs were tested by Boeing to be resilient to 50krad of total ionizing dose and immune to single-event upsets.Immunity to single-event upsets is achieved using a redundant architecture, where two identical and parallel powertrains with fault-tolerant control ICs are housed in a single high-density SM-ChiP package.
radiation-fault-tolerant DC-DC converter power modules,
housed in the new Vicor plated SM-ChiP™
package (image credit: SES)
Advanced communication satellites require high power density and low noise. Vicor soft-switching, high-frequency ZCS/ZVS power stages within metal-shielded ChiPs, reduce the powersystem noise floor, enabling signal integrity and total system performance with the requisite high level of reliability.
The complete power-source-to-point-of-load solution consists of four SM-ChiPs:the BCM3423, a100V nominal, 300 watt K = 1/3 bus converter in a 34 x 23mm package;thePRM2919, a 33V nominal 200W regulator in a 29 x 19mm package;and two VTM2919 current multipliers, a K = 1/32with an outputof 0.8V at 150Aand a K = 1/8 with an output of 3.4V at 25 amps. The solution powers the ASIC directly from the 100V power source with minimal external components and low-noise operation.
All of the modules are available in the Vicor high-density SM-ChiPpackage with BGA (ball grid array) connections and optional solder mask for the top and bottom surfaces.Operating temperature for the ChiPsis–30 to 125°C.
Contact Vicor for evaluation boards and samples.